How to Manually Select DHCP, PPPoE or Static IP During Initial Setup (Wi-Fi 6)

You can manually select the network configuration (DHCP, PPPoE, or Static IP) during the initial setup from the Vilo Living App. Please ensure your app is on version 1.0.169 for iOS & 1.0.177 for Android. This is only available for Vilo 6 (Wi-Fi 6) at this time. 

  1. Log into the Vilo App with your ISP Account.
  2. Tap “Add Vilo” if it’s your first time installing a network. If you’ve installed networks already, then tap on the “+” sign to add a new network.
  3. Go through the initial setup until you arrive at the “Detection Successful” page (this will be after activating the Wi-Fi network and adding it to your account) where the detected configuration will be shown.
  4. Select “Manual Configuration”
  5. From here you can select DHCP, PPPoE, or Static IP Access.
  6. You will see the network activation progress bar, followed by a “Success” confirmation. You can choose to input Subscriber information(or skip) and edit the SSID & password to complete the installation. 
Was this article helpful?
0 out of 0 found this helpful



Article is closed for comments.